Product Description
Recessed D-Ring 6,000 lb. Cap. Tiedown w/ Backing Plate - 4 pack: Automotive. To assist in making the proper tie-down choice the Federal D.O.T. Set of FOUR (4) D-Rings and FOUR (4) Backing Plates: Purchased individually @ $10.45 each the cost would be $41.80 - therefore you SAVE $8.85. This tie down attachment has a 6,000 lb. capacity* vertical pull weight rating. To install this attachment requires routing, or cutting a hole in the floor. This recessed d-ring has square holes punched for receiving carriage bolts, providing a smooth and relatively trip free inch surface. The steel attachment is zinc coated to inhibit corrosion. When in use the ring portion raises for application and lies down when not in use, thus creating a flush surface.This tie down attachment is plenty strong and is able to receive multiple tiedown straps simultaneously. To obtain maximum strength it is recommended to install these d-rings with bolts, lock nuts, and fender washers. For installation purposes it is easiest to cut a template and then transfer to the desired location. RECESSED D-RING SPECIFICATIONS: 1) The base measures 5 inch x 4-1/2. 2) Hole pattern is 3 inch x 3-1/2 inch on centers. Recessed dimension is 2-1/2 inch in diameter with a flat edge. 3) The 7/16 inch diameter ring measures 1-3/4. 4) The ring pivots on a 5/16 inch threaded stud. 5)The pan has a 1/4 inch drainage hole. The BACKING PLATE is used for support under the floor when installing the attachments, and prevents the bolts from pulling through. SPECIFICATIONS: 1) The backing plate measures 6-1/2 inch x 6-1/2. 2) Thickness is 11 gauge (a little thinner than 1/8). *3/8 inch holes. 3) 2-1/2 inch diameter cutout. 4) Steel backing plate is galvanized to inhibit corrosion. * RATED CAPACITY: Also known as assembly capacity inch or break strength inch is the minimum load a complete assembly can withstand before failure in a laboratory pull test when the product is NEW. WORKING LOAD LIMIT: The maximum load weight a tie-down should be subjected to during normal use. requires the W.L.L.
Shipping Weight: 8 pounds
|